Forney 20857 Tap Magic Industrial Pro Cutting Fluid, 4 oz

This stuff is awesome. Just a few drops is all you need.

Good fluid, but I wouldnt buy this in this bottle again. It likes to leak in my tool box out of the bottom of the cap and doesnt feed out fluid very fast at times.

Its good cutting fluid save my bits and makes them last longer:)

We only tap things once in awhile and normally just use some motor oil. We were taping a 10-32 thread and switched to Tap Magic, you could tell the difference immediately. This Tap Magic is a whole heck of a lot better than motor oil! I wish we were using this stuff years ago.

This stuff is necessary if you do much drilling or tapping. It will extend drill bit life for you and is critical to use for tapping holes.

Works Great.

Great stuff!

This is extremely helpful for drilling and tapping 3mm holes. It is amazing how much easier it is when using this...

I never knew how much of a difference oil like this could make on drilling and tapping. I saw this when ordering a new drill bit to replace one I had just burned up drilling through 1/8 thick steel. I had used the previous bit to drill two holes and was working on my third when it quit cutting. I bought this oil thinking I had little to lose, because the bits were running me $14.00 a pop and I had 7 more holes to drill. When I got the new bit and the oil I put a little oil on the tip and drilled the first hole. The oil helped the bit work so well that it reduced the time it took to bore through. I was able to finish the job without having to buy more bits. I later used the oil while tapping four new holes on an electric generator. The oil made the job a whole lot easier. A little may do the trick, but I find that if I am having trouble drilling or tapping, adding a little more helps too. Great product.

good